Mon-Fri 8AM-8PM, Sat-Sun 9AM-6PM

DCS Appliance Repair

We repair DCS appliances in your own home, across Des Plaines and the suburbs around it. What DCS actually manufactures is set out below, taken from the current range rather than from a generic list, and it matches what our technicians are equipped and trained to service.

Why the make changes the repair

DCS is known for professional dual fuel ranges, high output gas cooktops and outdoor grills. Engineering decisions like those determine how an appliance eventually fails, and therefore how it has to be tested. Working through parts in order of price arrives at the right answer eventually, by elimination, and the elimination appears on the customer invoice. We would rather read the stored error history and take a measurement.

Parts and warranty

Manufacturer DCS parts are used wherever they are still available. Where one has been discontinued, which happens on older and imported models, we tell you plainly that a high quality equivalent is the better or the only option, and the part number goes on your invoice either way. Every repair carries 30 days on our labor together with the manufacturer warranty on anything we install.

Before you book

Track down the model number first if you can. On DCS appliances it is usually on the door frame, behind the kick plate, inside a drawer runner or on the rear panel, depending on which appliance it is. If the plate is hard to read, send us a photograph when you book and we will read it for you. With the model confirmed, the parts that most often fail on your exact unit travel out with the technician, and that is the reason most of these appointments finish in one visit.

Where DCS work comes up most

In-home DCS oven / range, ice maker, refrigerator / freezer, wine cooler repair, with same day and next day appointments, one flat price agreed before the work starts, and no weekend surcharge.

Professional stainless steel range built into a home kitchen - DCS oven and range repair
Every DCS repair is carried out in your own kitchen or laundry room.

Book DCS service

The model number is what tells us which parts to load, so it is worth a minute finding it before you call.

Schedule an appointment

(847) 495-2170


DCS at a glance

  • Origin: New Zealand
  • Known for: Professional dual fuel ranges, high output gas cooktops and outdoor grills.
  • Manufacturer parts installed wherever available
Appliance types

What DCS builds, and what we repair

DCS makes the following appliance types, and we service every one of them in your home.

Professional gas and dual fuel ranges

Gas cooktops and rangetops

Wall ovens

Outdoor grills and side burners

Undercounter refrigeration and ice makers

Common problems

Recurring DCS problems

Patterns we have learned from returning to this make over the years. Recognizing one of them usually shortens the diagnostics considerably.

Griddle or burner not reaching full output

Gas pressure at the manifold, or a burner orifice sized for the wrong gas after a conversion. Both are measured rather than assumed.

Oven thermostat holding high

The sensor or the control. DCS ovens are heavily insulated, so a small calibration error shows up as browning long before it shows on the display.

Ignition module clicking on all burners at once

A single shorted electrode will make the whole module fire. Isolating which one it is takes only a few minutes.

Where we work

DCS repair in your town

In-home DCS service across the northwest suburbs and the North Shore, with the same warranty and the same flat price policy everywhere.

Other manufacturers we repair

FAQ

DCS repair questions

Do you repair the whole DCS range?

We service the full DCS line set out on this page, meaning professional gas and dual fuel ranges, gas cooktops and rangetops, wall ovens, outdoor grills and side burners and the rest of it. Tell us the model when you book and the parts most likely to be needed leave with the van.

Do you install genuine DCS parts?

Yes, wherever they are available. Where a manufacturer part has been discontinued we will tell you plainly that a high quality equivalent is the better or the only option, and the part number goes on your invoice either way.

How long does a DCS repair take?

Diagnostics run thirty to forty five minutes, and roughly three quarters of repairs are finished during that same visit because the parts that fail most often ride on the van. Anything that has to be ordered is normally back within a few business days.

Where is the model number on a DCS appliance?

Depending on the appliance it is on the door frame, behind the kick plate, inside a drawer runner or on the rear panel. Send us a photograph of the rating plate when you book and we will read it for you.

Book a DCS repair

Tell us the model when you book and the parts that fail most often on that unit leave with the van. It is the reason so many of these appointments end the same afternoon.

Call now Book online